Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 6 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Define the System Inputs and Outputs/Add Access Panels
Program the access panel push-button functions from
the access panel button template using the features
common to most panels.
(Added access panels inherit the button template
assignments.)
• Select the button function.
• Select the button color.
• Enter the button label text.
System Properties → Access Panels →
Access Panel Button Configuration (on
page 33)
Add access panel interface cards and access panels.
System Properties → Access Panels
Enable API cards (1–4).
Add access panels to each API card.
Select the access panel type—each added panel is
initially set to the functions of the access panel button
template.
Access Panel Interfaces Summary screen
(on page 29)
Edit the access panel description.
Set the access panel address (0–F).
Enable/disable supervision.
Access Panel Properties screen (on page
31)
Program the inputs to the I/O controllers:
• Enter a description of the input.
• Select type of switch connected to the input and
cable supervision (if applicable).
• Select the event triggered when the input is
active.
• Enable/disable the input’s auto-inhibit function.
System Properties → I/O Controller
Properties → Inputs Tab (on page 49)
Program the outputs to I/O controllers:
• Enter a description of the output.
• Select the inactive (idle) state of the relay output
(on open or closed).
• Select if the relay should follow the audio play of
the event which triggers the relay.
• Select the cadence of the relay activation
(normal, pulse, or interval).
System Properties → I/O Controller
Properties → Outputs Tab (on page 50)
Configure System Audio Mixing Parameters
Set the attenuation threshold level.
Set the mix threshold level.
System Properties → Global Audio Mix
Setup (on page 20)
To Next Page
Loading...
