Hubbell GAI-TRONICS E3 - Status Bar Components

Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 5 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Add System Events
Action
Screen
Add an Event.
System Events → Add Event (on page 76)
Enter an event description.
Select the Event type:
• live audio
• playback
• record/playback
• silent
• external
Add Event (on page 76)
For Live Audio Events:
• Select the audio source of the event.
• Select pre and post announcement tones.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
For Playback Events:
• Select the message to play.
• Select the playback mode (repeat, continuous).
• Select the cancel and acknowledgement options.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 77)
For Record/Playback Events:
• Select the audio source of the event.
• Select pre and post announcement tones.
• Select the playback mode (repeat, continuous).
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
For Silent Events:
• Select the cancel and acknowledgement options.
• Select the output and logic flags to activate.
For External Events:
• Select the audio source of the event.
• Select the cancel and acknowledgement options.
• Select the default broadcast zone.
• Select the output and logic flags to activate.
• Select an event chain.
Event Builder (on page 77)