Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 66 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Hang Up On Reg Failure—active calls terminate if the re-registration fails when selected. (Re-
registration is independent of active calls.)
Hang Up On RTP Failure—active calls terminate if the data rate drops below 250 bytes per second
when selected. (Excessive packet loss is present at this data rate.)
SP2 Properties
Party Drop Destination—The incoming call connects to the selected party line for two-way
conversation with SP2 handset users (see the SP2 Integration section).
Party Max Answer Delay—the amount of time (minutes/seconds) the telephone interface will wait for
an SP2 handset user to access the party line before disconnecting the call.
Party Max Duration— the maximum duration (minutes/seconds) the telephone caller and SP2 handset
user can talk on the party line before the call disconnects.
Party Extended Duration—time (minutes/seconds) to add to the PARTY MAX DURATION allowing
the call to continue if needed. The caller hears a beep, indicating the party line time limit is about to
expire.
1. Press the * button on the telephone's keypad to extend the conversation for the PARTY EXTEND
DURATION (minutes/seconds).
2. Repeat this process to further extend the conversation as needed.
Hang up On Party Disconnect—telephone calls terminate when the SP2 handset user hangs up
(following a party line conversation).
To Next Page
Loading...
Need help?
General
