Humminbird SOLIX series User Manual

166
Radar & Navigation
NAVIGATION IN RADAR VIEW
Y
ou can mark waypoints and start navigation from the Radar View. See Introduction to Navigation for more features and information.
NOTE: To display navigation data on the Radar View, see Change the Radar View Data Overlays: Display Navigation Data.
Mark a Waypoint
There are a variety of ways to mark a waypoint in the Radar View. The basic instructions are shown here. See Introduction to
Navigation for more features and information.
Mark a Waypoint at the Vessel Position
Mark a Waypoint at the Cursor Position
Touch Screen
1. Tap Radar in the status bar.
2. Select Mark.
3. Select Waypoint.
Keypad
1. Press the MARK key twice.
Touch Screen
1. Press and hold a position on the Radar View.
2. Select Waypoint.
Keypad
1. Use the Joystick to move the cursor to a position on
the chart.
2. Press the MARK key twice.

Humminbird SOLIX series Specifications

General

Depth-Sonar Standard	Up to 1, 500 feet (varies by model)
Interface	Touchscreen
GPS	Yes
Cartography	Humminbird Basemap
Target Separation	2.5 inches
Networking	Ethernet, NMEA 2000
Memory Card Slot	Yes
Waterproof	IPX7
Operating Frequency	1.2MHz
Dimensions	Varies by model
Weight	Varies by model
Display Size	10.1", 12.1"
Display Resolution	1280 x 800 pixels (varies by model)
Operating Temperature	-15°C to 55°C (5°F to 131°F)