Humminbird SOLIX series User Manual

223
Sonar & Navigation
Navigate to a Position
Use the instructions in this section to start navigation to a position in the Sonar Views. See Introduction to Navigation for more
information about these features.
Start Navigation
NOTE: In Side Imaging Views, if SI Navigation is turned on, the boat icon will turn to indicate the direction the boat needs to turn
to reach the next waypoint during navigation (see Customize the Side Imaging View: Turn on/off SI Navigation).
Cancel Navigation
1. During navigation, tap Sonar in the status bar. Select Go To.
OR
Press the GO TO key.
2. Select Cancel Navigation.
Touch Screen
1. Press and hold a position on the Sonar View.
2. Select Go To Cursor.
Keypad
1. Press the GO TO key.
2. To start navigation to a saved position, select
Nav Data. Select a saved position, and press the GO TO
key.
To enter a latitude/longitude position, select Lat/Long.
3. Continue to follow the on-screen prompts to start
navigation.

Humminbird SOLIX series Specifications

General

Depth-Sonar Standard	Up to 1, 500 feet (varies by model)
Interface	Touchscreen
GPS	Yes
Cartography	Humminbird Basemap
Target Separation	2.5 inches
Networking	Ethernet, NMEA 2000
Memory Card Slot	Yes
Waterproof	IPX7
Operating Frequency	1.2MHz
Dimensions	Varies by model
Weight	Varies by model
Display Size	10.1", 12.1"
Display Resolution	1280 x 800 pixels (varies by model)
Operating Temperature	-15°C to 55°C (5°F to 131°F)