Hunter DSP9200 Series - Using Wheel Dimension Control Knobs

Press the “Left Plane Split Weight
®
” button to split weights on the Left Plane.
Refer to “Split Weight
®
Feature,” page 51.
Press the
“Oz/Gm” button to view balancing weights in ounces or grams.
Press the
“Right Plane Split Weight
®
” button to split weights on the Right
Plane. Refer to “Split Weight
®
Feature,” page 51.
Press the
“CenteringCheck
®
” button to check the accuracy of the mounting of
the tire/wheel assembly on the balancer shaft. Refer to “CenteringCheck
®
,” page 25.
Using Wheel Dimension Control Knobs
The control knobs are located to the left of the control panel. The control knobs are
used to manually input wheel dimension data. The control knobs are identified as the
distance, width, and diameter control knobs.
Wheel dimension control knobs are used for manual data entry when required.
Changes to wheel dimensions are made by rotating the knobs. The control knobs are
digital encoder design and variable speed. Rotating slowly will change increments in
single digits. Rotating quickly will advance and move increments at an increased rate.
12
x
1. Getting Started DSP9200 Series Balancer Operation Instructions