Hunter DSP9200 Series - Detailed Balancer Calibration Steps

Balancer Calibration
Press the “Setup/Cal” button once. “CAL” is displayed.
Press the “Enter” button to begin calibration.
Do not install cal weight. Lower the hood and press the “Start” button to spin (if “Hood
Autostart” is disabled).
Install cal weight on left side of hub faceplate in either hole, align cal weight at TDC,
and press the
“Enter” button. Spin.
Move cal weight to right side of hub faceplate in same hole.
Spin, display reads “CAL RDY.”
DSP9200 Series Balancer Operation Instructions 5. Maintenance and Calibration
x
59