All weight plane displays should show “zero.” Split Spoke® balancing procedure is
complete.
4.11 Automatic Weight Recalculation and Dimension Preservation
When dialing a rotary encoder knob, each click of the knob (changing a dimension)
causes the weights to be recalculated. The benefit is that without re-spinning, you
have the unique ability to relocate the desired weight locations and see the resulting
weights and placement angles updated in real-time.
When attempting to dial in a value not allowed or exceeding a limit, the rotary
encoder knob will make a “ratcheting” sound. For example: Trying to dial in a wheel
width under 1.5 inches, will cause a “ratcheting” sound.
When entering STANDARD, MIXED WEIGHTS, or TWO ADHESIVE WEIGHTS
MODE, the last dialed in dimensions for that procedure are recalled and displayed.
The weight amounts and angles for these dimensions are recalculated and
displayed. The benefit is that without re-spinning the wheel, you have the unique
ability to switch between balancing procedures to determine the best combination of
weight types for the tire/wheel assembly.
NOTE: The exception to this rule is when changing a dimension in
STANDARD and then entering an ALU mode. The last ALU
dimensions used are replaced by new dimensions based on
the new STANDARD dimensions.
Any change between STATIC and DYNAMIC, or Enabling/Disabling the “blind” and
“rounding” also preserves dimension information and recalculates the weights.
4.12 Storing and Recalling Wheels
The balancer can store and recall SETUP information, balance procedure, and wheel
dimensions for up to four specific wheels. Storing and recalling can also be used to
allow up to four technicians to use the wheel balancer at the same time.
Storing a Wheel into Memory
Enter SETUP information (oz/gm, diameter in/mm, and width in/mm), balance
procedure, and wheel dimensions for a specific wheel.
Press the
“Enter” button. -0- appears indicating that the store/recall mode is
activated, but no wheel has been selected.
Press the
“Next” button until wheel 1, 2, 3, or 4 is selected.
Press and hold the
“Enter” button for a minimum of two seconds to store wheel.
A confirmation beep will confirm that the wheel has been stored into memory and
wheel index turns into weights for the recalled wheel.
Recalling a Wheel from Memory
Press the “Enter” button. -0- appears indicating that the store/recall mode is
activated, but no wheel has been selected.
Press the
“Next” button until stored wheel 1, 2, 3, or 4 is selected.
Press the
“Enter” button briefly (less than two seconds) to recall stored wheel
dimensions and SETUP information.
DSP9200 Series Balancer Operation Instructions 4. Balancing Features and Options
55
To Next Page
Loading...