Hunter DSP9200 Series - Balancing Features and Options; Servo-Stop Feature Overview; Servo-Stop Aided Clip-On Weight Placement; Servo-Stop Aided Adhesive Weight Placement

4. BALANCING FEATURES AND OPTIONS
4.1 Servo-Stop
Servo-Stop Wheel Weight Positioning
After the balance spin, the wheel assembly will automatically locate, brake, and hold
the wheel assembly in the correct weight installation location.
Disabling Servo-Stop
Press the red “Stop” button to disable servo-stop.
Turning On Servo-Stop
Press the green “Start” button, or step on the foot pedal with the safety hood
in the raised position to turn on servo-stop.
Servo-Stop Aided Clip-On Weight Placement
Spin the wheel using Clip-On Weights selection. The wheel will stop with the clip-on
weight location at TDC.
Pressing the green
“Start” button or stepping on the foot pedal will
automatically rotate the wheel to place the next weight location at TDC.
Servo-Stop Aided Adhesive Weight Placement
The inner Dataset
®
arm can be used to assist in proper placement of adhesive
weights. Using dimensional information previously obtained, the display identifies the
exact location of the weight plane and the current position of the inner Dataset
®
arm.
Wheel dimensions must be entered using the inner automatic Dataset
®
arm while in
the desired balance mode. Servo aided weight placement is not allowed if wheel
dimensions were changed by turning the knobs, or if dimensions were entered using
the automatic inner Dataset
®
arm before changing the balance mode (i.e. changing
from clip-on mode to clip-on/adhesive mode).
Spin the wheel using Mixed Weights or Adhesive Weights selection. The wheel will
stop with one of the adhesive weight locations at BDC.
Shape the weight to a contour similar to the curve of the rim.
With one of the weight locations at BDC and servo on, pull the inner Dataset
®
arm
out from the base.
The wheel will automatically rotate to place the weight location where the inner arm
will contact the rim.
The “target” inner arm distance will be shown on the rim distance dimension.
If a weight is being placed on the left plane, the live inner arm distance will be
flashing on the right weight display and the amount of weight to be placed is shown
on the left weight display. The displays are reversed if a weight is being placed on the
right plane.
Continue to pull out the inner arm until the “live” distance equals the target distance.
Maintaining that distance, rotate the Dataset
®
arm toward the inner rim surface, and
then apply the adhesive weights to the rim by pressing the adhesive weight release tab.
DSP9200 Series Balancer Operation Instructions 4. Balancing Features and Options
x
47