Hunter DSP9200 Series - Measuring the Inside Wheel Diameters (for Adhesive Weights)

For example: The illustration below shows the installation of two adhesive weights.
The weight locations are at the minimum allowed distance.
If the weight locations are moved any closer together using the Dataset
®
distance
knob or auto Dataset
®
arm, the distance digits will blink and the weight amount
display will change to - - - - - -. Move either weight location away from the other
weight location to resolve this situation before proceeding.
*An optimum chosen position by the operator would be at the extreme left edge of
the wheel and extreme inside right edge (280 and 400 as shown). This would lessen
the total amount of weight required in order to perform a correct dynamic balance.
Measuring the Inside Wheel Diameters (For Adhesive Weights)
If other wheels have been removed from the vehicle, it will be easier to measure
inside rim diameters on an unmounted wheel. Use rim width calipers or a tape
measure to make the measurements for both the plane right and left plane adhesive
weight location internal wheel diameters as shown below.
Measure the rim inside diameters at the same location where the wheel weight is to
be placed and set the wheel diameter knob to the measurement:
OR
DSP9200 Series Balancer Operation Instructions 3. Balancing a Wheel
x
31