Hunter DSP9200 Series - Front;Back Cone Mounting Technique

Front/Back Cone Mounting
Cone mounting is one of the most common and reliable ways to mount wheels on
balancers.
Select the proper wheel mounting cone by placing it in the center bore of the wheel to
be balanced. Select the cone that contacts the wheel nearest the center of the cone.
Place the wheel mounting cone on the spindle against the spring plate. Mount the
wheel with the inner rim facing the balancer and centered on the cone.
Install the clamping cup and wing nut on the spindle shaft against the wheel and
secure the entire assembly by firmly tightening the wing nut, while depressing the
foot pedal to hold the spindle in place.
NOTE: If equipped with optional Spindle-Lok
®
foot pedal, depress
and hold down while tightening the wing nut. Holding the
shaft locked while tightening the wing nut improves centering
accuracy.
Slowly roll the wheel toward you during the initial tightening
of the wing nut. This aids in accurate wheel centering and
increased repeatability, since the wheel is allowed to roll up
the taper of the cone as opposed to forcing it to slide up the
cone.
STANDARD STEEL
WHEEL RIM
WHEEL
MOUNTING
CONE
SPINDLE
SHAFT
PLASTIC
CLAMPING
CUP
WING NUT
STANDARD
WHEEL
INSIDE
SURFACE
CAPTIVATED
SPRING
20
x
3. Balancing a Wheel DSP9200 Series Balancer Operation Instructions