If the SmartWeight® balancing procedure requires
correction weights, wheel dimensions will be required.
Close the hood and perform a spin.
After the spin is complete, the screen will display the
amount and location of corrective weight necessary.
Install the weights as indicated on the screen using the
TruWeight® feature. Lower the hood to re-spin and check
the balance.
The balancer displays “OK,” indicating that the force
levels are reduced to within the acceptable tolerances.
4.4. Switching from SmartWeight® Balancing to Traditional Dynamic Balancing
At any time, SmartWeight® Balancing Technology can be switched to
standard balancing provided that both standard and SmartWeight®
balancing modes are enabled in setup. Touch the SmartWeight®
button to display the SmartWeight® menu buttons.
NOTICE
SmartWeight® Balancing Technology is the default
balancing method and is the most recommended way
to accurately balance wheel / tire assemblies.
Touch the Disable SmartWeight® button. The balancer is now in
traditional dynamic balancing mode.
NOTICE
When changing to traditional dynamic balancing mode,
weight amounts as well as weight placement locations
change.
4.5. Switching from Traditional Dynamic Balancing to Traditional Static Balancing
In non-SmartWeight® mode, the balancer can be switched from dynamic balancing to static balancing.
HD Elite Wheel Balancer
Page 37 of 51
To Next Page
Loading...
