SmartWeight® Balancing Technology Traditional balancing technology
Both of these methods can balance tires dynamically. The main difference being that SmartWeight® will reduce the amount
of corrective weight in a basic wheel balancing situation and automatically optimize static force reduction and single plane
weight placement.
4.3. Using SmartWeight® Balancing Technology
The SmartWeight® balancing forces display varies
greatly from the standard balancing display.
SmartWeight® tire graphs independently display the
static and couple forces within a tire/wheel assembly. A
single plane (static) mode and non-round o modes are
no longer necessary.
The traditional “static” and “dynamic” modes are
eliminated. The traditional non-round o mode is
eliminated. These modes are no longer necessary with
SmartWeight® balancing.
The red-dotted line represents the acceptable amount of
force the tire and wheel assembly can have that will not
result in a ride problem. Any forces below that line will
be shown in green. Any forces that are above that level
will be shown in red and indicate an excessive amount of
force.
Install a tire/wheel assembly as normal. Rim
measurements are not required to determine if the
balance forces are exceeded. Lower the hood and spin.
Prior to balance spin, the tire graphs will display no color. The SmartWeight® balance force graphs will display red for
excessive forces and green for acceptable amounts of force.
HD Elite Wheel Balancer
Page 36 of 51
To Next Page
Loading...
