Springs, 98-403-2, must be installed with the concave sides facing each other. When correct, only the outer edges of
the springs will contact each other, creating a clam appearance. All the pin assemblies must have the springs installed
consistently in this manner.
If the installation and removal of pin sleeves becomes dicult, clean inside of pin sleeves and the pin assemblies, and then
apply light machine oil to the mating surfaces. If pin sleeves do not stay on pins, clean excess oil from inside of pin sleeves
and the pin assemblies. If the problem persists, replace the two O rings, 124-149-2, on the ends
7.4. Maintenance Schedule
HD Elite Wheel Balancer
Page 49 of 51
To Next Page
Loading...
