Table 5. Follow schedule to keep balancer performing at its best
Maintenance Schedule Perform the following Maintenance
Daily • Spindle Maintenance - Keep the spindle shaft assembly and wing nut threads clean
and lubricated. Clean the spindle threads by running the edge of a rag between the
threads while turning the spindle by hand. Lubricate the shaft with a coating of light
lubricant with Teon® such as Super Lube® by Loctite after cleaning.
Do not lubricate the spindle hub face-mounting surface. This could cause slipping
between the wheel and the hub face. Keep the hub face-mounting surface clean and
dry.
• Collet maintenance - Keep the mounting collets clean and lubricated. Lubricate with
a coating of light lubricant with Teon® such as Super Lube® by Loctite. Inspect
cones for excess wear, dings, burrs, or other damage that may prohibit proper
centering.
Do not use cones in any way that is not described in the operation manual. This could
cause damage to the mounting cone and not allow for proper mounting of the wheel.
• Inspect wingnut and clamp cup for excessive wear or damage.
• Cleaning the console - When cleaning the console use the included Armor All Glass
wipes to wipe o the display console and cabinet. Do not spray any type of cleaning
solution directly onto control panel or LCD resistive touch screen. Do not use shop
air to clean the display. Power should be o prior to cleaning the LCD resistive touch
screen
Periodically (when
balancer chases weight
on check spin)
• Perform a QuickCal Check to determine if calibration is necessary. This should be
performed after balancer has been in operation for at least 10 minutes.
Monthly • Inspect inlet air lter/dryer - clean, replace as necessary
Semi-Annually Preventative maintenance visit by Hunter Service Representative which will include all
the above in addition to the following:
• Perform audit check (quality report for vibration control system)
• Perform full system diagnostics (including air system)
• Load roller friction material inspection
• Check printer operation
• Cone inspection with dial indicator
• Check belt tension
• Full system calibration
NOTICE
The end user is responsible for replacement of all consumable items such as printer ink cartridges, cleaning
wipes, and batteries.
CAUTION
Do not use shop air to clean the LCD resistive touch screen. Shop air could be wet, dirty, or too powerful for the
display and can cause problems with the display.
HD Elite Wheel Balancer
Page 50 of 51
To Next Page
Loading...
