Hunter HD Elite - Motor Drive; Servo-Stop and Spindle-Lok

Dynamic mode, blinding/rounding is disabled: Static mode, blinding/rounding is enabled:
3.6. Motor Drive / Servo-Stop and Spindle-Lok
WHEEL CLAMPING
DANGER
Keep clear of clamping components during shaft rotation.
WARNING
Wheel clamping does not tighten the wing nut! In wheel clamping rotation, torque allowed is minimal.
Therefore, the wing nut must still be hand-tightened before balancing.
NOTE
Because of the software limited torque control, you must loosen the wing nut before you remove it.
MOTOR DRIVE / SERVO-STOP
The intelligent DC motor drive on the HD Elite Balancer
is able to position and hold the tire assembly in position
for weight application, apply dierent amounts of torque,
and control the speed and direction of the spindle.
When the “Start” button is touched with the hood in the
raised position, while weights are showing, the motor will
automatically rotate the wheel to the next weight plane
and hold the assembly in position for weight or mark
application. Alternatively, touching the weight amounts
will achieve the same results.
SPINDLE-LOK® FEATURE
Depressing the foot pedal will lock the spindle. Locking the spindle will stabilize the wheel for attaching weights at precise
locations if automatic weight positioning is disabled,and will allow for tightening and loosening of the wing nut.Do not use
the Spindle-Lok® as a brake to stop a spinning wheel.
NOTE
Depressing the foot pedal will cancel Servo-Stop.
HD Elite Wheel Balancer
Page 22 of 51