Hunter HD Elite - Rim Dimension Manual Entry

CAUTION
Use of controls or adjustments or performance of procedures other than those specied herein may result in
hazardous radiation exposure.
With the servo enabled, attach the adhesive weight using the weight amount shown for the left weight plane on the screen.
TruWeight® shows the operator exactly how to place the weights on the wheel. Place them exactly as displayed on the
screen.
Touch the green “START” button with the safety hood in
the raised position.
NOTICE
Optionally, pressing the next plane weight
amount will rotate the wheel to the next
weight plane.
Close the safety hood to perform a check spin.
Left and right weight plane displays should show “OK”
after the check spin.
Enable Dragging Feature
The Enable Dragging feature allows the user to drag tape weights to a specic area of the wheel.
Touch the “Measurements” icon on the left side of the screen after a balance spin. Touch the “Enable Dragging” button on
the right hand side of the screen. Users can now drag the tape weight(s) as desired.
3.9. Rim Dimension Manual Entry
3.9.1. Rim Dimension Manual Entry - Tape/Tape
In the event of an SmartScan™ failure, balancing can still
be performed by using a tape measure to manually input
rim dimensions.
Press the dimension button on in the upper left-hand
portion of the screen.
HD Elite Wheel Balancer
Page 28 of 51