Occasionally, regardless of the weight mode, a single tape weight is shown in the middle of the wheel. Place the weight as
shown on-screen. The crucial task is to line up the center of the weight with the laser line. The depth of placement does not
need to be exact, use features of the rim prole to determine the location.
3.8.1. Balancing Procedure Using Clip-On Weights
Verify the correct clip-on weight type will be used for the wheel that is
being balanced.
Verify that the wheel is clean and free of debris. Remove all previous
weights.
Mount tire/wheel assembly. Close safety hood
Touch the green “START” button if “Hood Autostart” is disabled.
As the wheel is spinning, the amount(s) of corrective weight(s)
needed will be shown on the screen. This time can be used to nd
and prepare the needed weights.
NOTICE
Once weight amounts are shown on the screen, they can be toggled to display either ounces or grams by
selecting the “oz” or “g” graphic shown after the weight amount.
After wheel comes to a complete stop, raise the safety hood.
NOTICE
If Auto Hood is enabled, the hood will raise automatically.
The HD Elite® will nd the top-dead-center (TDC) for the rst weight
plane if “Servo-Stop” is enabled. “Servo-Stop” will hold the wheel in
the TDC position while the weight is applied.
Attach the weight amount shown on the screen for the selected
weight plane to the correct side of the wheel.
HD Elite Wheel Balancer
Page 24 of 51
To Next Page
Loading...
