Hunter HD Elite - Getting Started; Introduction; Safety Instructions; Electrical

1. Getting Started
1.1. Introduction
This manual provides operation instructions and information required to operate the HD Elite Balancer. Read and become
familiar with the contents of this manual prior to operating the HD Elite Balancer.
The owner of the HD Elite Balancer is solely responsible for arranging technical training. The HD Elite Balancer is to be
operated only by qualied trained technicians.Maintaining records of personnel trained is solely the responsibility of the
owner and management.
This manual assumes the technician has already been trained in basic balancing procedures.
1.1.1. Corporate Information
Hunter Engineering Company
Addr: 11250 Hunter Drive, Bridgeton, MO 63044 USA
Ph: 314-731-3020
Web:
www.hunter.com
References
This manual assumes that you are already familiar with the basics of tire balancing.
1.2. Safety Instructions
Read all instructions before operating the HD Elite Balancer. Read and follow the instructions and warnings provided in the
service, operation and specication documents of the products with which this HD Elite Balancer issued (i.e., automobile
manufacturers, tire manufacturers etc.).
Do not operate equipment with a damaged cord or equipment that has been dropped or damaged until a Hunter Service
Representative has examined it.Always unplug equipment from electrical outlet when not in use.
Never use the cord to pull the plug from the outlet.Grasp plug and pull to disconnect. If an extension cord is necessary, it
must have a current rating equal to or more than that of the equipment. Cords rated for less may overheat. Arrange the cord
so that it will not be tripped over or pulled.
Verify that the electrical supply circuit and the receptacle are properly grounded. To reduce the risk of electrical shock, do
not use on wet surfaces or expose to rain. Verify the appropriate electrical supply circuit is the same voltage and amperage
ratings as marked on the balancer before operating.
DANGER
DO NOT ALTER THE ELECTRICAL PLUG. Plugging the electrical plug into an unsuitable supply circuit will
damage the equipment and may result in personal injury.
To reduce the risk of re, do not operate equipment near open containers of ammable liquids (gasoline). Read and follow
all caution and warning labels axed to your equipment and tools. Misuse of this equipment can cause personal injury and
shorten the life of the balancer. Keep all instructions permanently with the unit.
Keep all decals, labels, and notices clean and visible.To prevent accidents and/or damage to the balancer, use only
Hunter HD Elite Balancer recommended accessories. Use equipment only as described in this manual. Never stand on the
balancer. Wear non-slip safety footwear when operating the balancer.
HD Elite Wheel Balancer
Page 3 of 51