Press the Manual Entry button in the upper right-hand
portion of the screen.
Use a tape measure to measure the lengths called out
on-screen.
Touch each box and enter the appropriate measured
dimensions. When nished, press OK to end manual
dimension entry.
3.9.3. Blinding and Rounding
In non-SmartWeight mode the balancer can display either an “actual” or “blinded and rounded” amount of imbalance.
“Blind” is a tolerance or amount of imbalance required before an imbalance amount is displayed. “Round” allows the
balancer to display weight imbalance to a desired increment. The blind and round values can be changed in the “Setup”
procedure.
While in the “Balance” primary screen, blind and rounding may be disabled by touching the screen to highlight the
magnifying glass. The actual amounts of imbalance for the selected mode will be displayed when “Blind and Rounding” are
disabled as shown below.
HD Elite Wheel Balancer
Page 30 of 51
To Next Page
Loading...
