Hunter HD Elite - Specialized Mounting Conditions

Front Collet Mounting
NOTICE
Front collet mounting is generally not
recommended. It should only be used in
instances where traditional backside collet
mounting is not possible.
This procedure utilizes a collet inserted from the front
side of the wheel instead of the backside as previously
described.
Heavy Wheel Centering
Heavy wheel centering may benet by (1) pulling the tire away from the hub face at top dead center while tightening the
wing nut or (2) use of optional wheel lift to position heavy wheel onto shaft and cone. This helps the wheel to overcome
gravity against the hub or spacer.
3.3. Specialized Mounting Conditions
Collet / Flange Plate Mounting
Some wheels may be centered using the lugholes and center bore with a ange plate and collet. It is important that a back
mounted collet be used to support and center the wheel when using ange plates.
Flange plates are useful when the wheel cannot be properly centered off the hub bore with a collet alone because of
improper t, interference, or lack of a center hole.
Insert Index Pin into the Flange Plate as follows:
HD Elite Wheel Balancer
Page 16 of 51