Decal HD Elite warns the operator not to remove the cover of the HD Elite because of the risk of electrical shock and not to
use below garage oor level.
ETL certication standards are outlined on Decal HD Elite. Additionally, users are cautioned not to use the balancer below
garage oor level.
A manufacturer’s identication label is also on the rear of the balancer.
1.5. Precautions
POWER SOURCE
The HD Elite Balancer is intended to operate from a power source that will apply
230VAC +10% / -15%, 10amp 50/60 Hz, power cable includes NEMA 20 amp
plug,L6-20P, between the supply conductors of the power cord.
The power cord supplied utilizes a twist lock connector, NEMA L6-20P. This
machine must be connected to a 20 amp branch circuit. Please refer all power
source issues to a certied electrician.
Short-circuit current rating (SCCR ) of the electrical equipment is 5 kA.
CAUTION
A protective ground connection, through the grounding conductor in the power cord, is essential for safe
operation. Use only a power cord that is in good condition.
HD Elite Wheel Balancer
Page 6 of 51
To Next Page
Loading...
