Hunter HD Elite - TPMSpecs Feature & Hunter Help

This Laser Product is designated as Class 2M during all procedures of operation.
WARNING
Never look directly into the laser. Doing so may cause serious injury.
Table 3. Operation accessible radiation elds
Wavelength: 635-660nm
Laser Power for Classication: < 1mW via 7mm aperture
Beam Diameter: < 5mm at aperture
Divergence: < 1.5mrad x < 2rad
Transverse Beam Mode: TEM00
Specic Precautions / HammerHead® TDC Laser System
DANGER
Laser Light: DO NOT STARE INTO BEAM. Class 2M Laser Product. 635nm <1mW CW. Classied Per IEC
60825-1, Ed 1.2, 2001-08
Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice
No. 50, dated July 26, 2001.
WARNING
Use of controls, adjustments, or performance of procedures other than those specied herein may result
in hazardous radiation exposure. This Laser Product is designated as Class 2M during all procedures of
operation.
Do not stare into the beam or view directly with optical instruments. Doing so may cause serious injury.
Do not intentional use a reective device to enhance or re-direct the laser. Do not operate the laser if the cover
or seal is damaged.
There is no required maintenance or service to keep the HammerHead™ TDC Laser System in compliance. The laser is not a
eld serviceable or an adjustable part.
Any necessary repair or maintenance should be done by the factory only. The HammerHead™ TDC Laser System has no
eld serviceable parts.
The unit should never be opened or modied.
3.11. TPMSpecs™ Feature & Hunter Help
TPMSpecs™ Feature
NOTICE
TPMS specications can also be found on Hunter Aligners (with WinAlign 11.0 and greater) and online at
UnderCarInfo.NET (subscription service).
HD Elite Wheel Balancer
Page 32 of 51