DNS Address (set by your wireless router)
Network Test Button
All settings on this page are provided to the controller by your wireless router when it first
connects via a protocol, known as DHCP. If any of these settings appear incorrect please
change them in your wireless router.
Once the controller has successfully connected to your wireless router the Test Network
button can be used to test network connectivity for troubleshooting purposes. The network
test will verify connectivity to 4 destinations –
Test Network
Message Description Checking WiFi Performs a ping test to the Gateway address listed in the Network Status
screen. If this test fails, check that you don’t have MAC address filtering enabled on your router.Checking
DNS Performs a ping test to the DNS address listed in the Network Status screen. If this test fails, check that
the DNS address is correct – if it is wrong then correct the DNS address under DHCP Settings on your wireless
router. It is possible that this test may fail if the DNS server doesn’t accept ping requests which do not indicate
an issue.Checking Internet Performs a ping test to the Google server at IP address 8.8.8.8. This is a well-
known server which accepts ping requests on the internet. If this test fails then it indicates an issue with the
internet configuration of your wireless router.Checking Hydrawise Performs a ping test to the Hydrawise
servers. If this test fails then it may indicate an issue with the internet configuration of your wireless router.
Controller - Viewing Time and
Date
Time and date settings are synchronized with the settings that you configure in the
Hydrawise app. The timezone is set based on the location you entered during the app
wizard.
Time and Date
To Next Page
Loading...
Need help?
General
