Testing controller voltage
Test Wi-Fi on the controller
Test Water Supply
The water could be been shut off to the zone valves. Go to the zone valve and give the
solenoid (where the wires are connected) a ½-turn counterclockwise. If the valves have
water, the sprinklers will come on even without the controller. See the illustration below for
activating the valve solenoid manually:
If the sprinklers turn on by manually twisting the solenoid, follow the next step to check for
proper voltage.
Test Controller Voltage
To confirm proper voltage is getting to the valves using a voltmeter, follow the steps below:
1. From the Home screen, navigate to the Zone Summary screen by
pressing Zones.
From the Zone Summary screen, touch the zone you wish to view. The
Zone Summary screen shows the status of six zones at a time. To view
the next or previous group of zones, use the Next and Previous buttons.
The current range of zones that you are viewing is indicated at the top of
the screen.
From the Zone Status screen, you can manually start a zone using the
Run Now button. When started, the zone will run for the zone’s default
configured run length. This can be overridden by clicking on Run Time
prior to manually starting the zone. When a zone is running, the Run Now