Offline Mode - Run the Setup
Wizard
Please follow the steps below to run the setup wizard in offline mode. Refer to Setting
Controller to Offline Mode [27] or How to Factory Reset Controller [28] before running the
wizard.
1. From the Connection Wizard screen, tap on Configure Offline. If you select OK, you
will proceed to the online setup wizard.
2. Tap OK to move on to the next step.
3. Enter in today’s date if it hasn’t already been set or if it is incorrect.
4. Enter today’s time if it hasn’t already been set or if it is incorrect.
5. From this screen, tap OK.
6. Please assign your Master Valve if you’re running one as advised on the previous
screen. Otherwise, keep Not Assigned selected and tap Confirm.
7. Tap OK.
8. You can now enter (in minutes) the run length you want for your default zone run
time. Then tap OK.
9. Tap OK to proceed to the next screen.
10. Next, set how often each zone will run. As advised on the previous screen, you can set
individual frequencies for each zone.
11. Tap on OK to proceed.
12. From this screen, you can manually configure each zone according to your desired
schedule. Simply tap on Add to add a program start time and follow the steps below.
You can toggle between zones by tapping on Next/Previous or you can leave the start
time to APPLY to ALL ZONES.
To Next Page
Loading...
Need help?
General
