20
Setting Event Day(s) O
The X-Core
®
allows you to program a No Water Day(s). This feature is
useful to inhibit watering on specic day(s). For example, if you always
mow the lawn on Saturdays, you would designate Saturday as a No
Water Day so that you are not mowing wet grass.
1. Turn the dial to the WATER DAYS position.
2. Enter an interval watering schedule as described on page 19.
3. Press the button to scroll to the No Water Days at the bottom of
the display. MO will be ashing.
4. Use the button until the cursor is at the day of the week you wish
to set as a No Water Day.
5. Press the button to set this day as a no water day. The will il-
luminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are o.
NOTE: You also have the option in the interval
watering schedule to program Odd or Even days o.
Automatic Watering
Aer programming the X-Core, set the dial to the RUN
position to enable automatic execution of all selected
watering programs and start times.
System O
Valves currently watering will be shut o aer the
dial is turned to the SYSTEM OFF position for two
seconds. All active programs are discontinued and
watering is stopped. To return the controller to
normal automatic operation, simply return the dial
to the RUN position.
Programmable Rain O
This feature permits the user to stop all
programmed waterings for a designated period
from 1 to 7 days. At the end of the programmed
rain o period, the controller will resume
normal automatic operation.
1. Turn the dial to the SYSTEM OFF position.
Wait for OFF to be displayed.
2. Press the button as many times as
needed to set the number of days o
(up to 7 days).
3. Turn the dial back to the RUN position at which
OFF, a number, the
and icons will be
displayed.
The days o remaining will decrease at
midnight each day. When it goes to zero,
the display will show normal time of day and
normal irrigation will resume at the next
scheduled start time.
RUN
RUN
PROGRAMMING THE CONTROLLER
To Next Page
Loading...
Need help?
General
