22
Manually Run a Single Station
1
1. Turn dial to MANUAL – ONE STATION position.
2. Station run time will ash in
the display. Use the button
to move to the desired station.
You may use the or button
to select the amount of time for
a station to water.
3. Turn the dial clockwise to the RUN position to run the station (only
the designated station will water, then the controller will return to
automatic mode with no change to the previously set program).
Also see One Touch Manual Start and Advance.
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the
button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B or C by pressing the
button.
3. The station number will be ashing. Press the
button to scroll
through the stations and use the
or button to adjust station run
times. (If no buttons are pressed for a few seconds during step 2 or 3,
the controller will automatically begin watering).
4. Press the button scroll to the station you wish to begin with. Aer
a 2 second pause, the program will begin. At any time during the
manual cycle, you can use the
or buttons to navigate from sta-
tion to station manually.
ATION
1
PROGRAMMING THE CONTROLLER
To Next Page
Loading...
Need help?
General
