11
INSTALLATION – INSIDE MOUNT
■
Attach the installation brackets using the screws provided.
IMPORTANT: Be sure the front edges of the installation brackets are level and aligned to
each other. Use shims if necessary to level the brackets.
Mount the Headrail
■
Mount the headrail into the installation brackets. Do not remove any components from the
headrail. Both end plates should remain attached to the ends of the headrail.
➤
Place the front groove on the headrail onto the front lip of the installation bracket.
➤
Position the end of the headrail opposite the fabric stack flush against the jamb.
This leaves a gap on the stationary rail side. The stationary rail fills this gap when
anchored.
➤
Rotate the rear of the headrail up and push back until the headrail snaps in place.
Front of Bracket
Snap in
Place
Gap Left Stack Shown Flush
To Next Page
Loading...
