HunterDouglas Duette - Outside Mount Installation

INSTALLATION – OUTSIDE MOUNT
6
Outside Mount
Mount the Installation Brackets
■
Center the headrail over the window opening at the desired height. Measure the width of
the window and use a pencil to mark the center of the window. Measure the width of the
headrail and mark the center of the headrail. Line up the center marks.
■
Mark end bracket locations 8" in from each end of the headrail.
➤
Mark the locations of any additional brackets, spaced evenly between the two end
brackets. Mount into wood whenever possible.
■
Determine where to place the top of the installationbrackets.
➤
Add the desired floor clearance to the ordered
height of the shade. The ordered height can be
found on the shipping box, headrail, or shade
bag. A minimum of
1
⁄ 2 " floor clearance
is recommended.
➤
Measure the total distance up from the floor.
This is where to place the top of the
installation brackets.
➤
A minimum flat vertical surface of 1
1
⁄ 4 " is
required to mount the brackets.
CAUTION: The rear of the brackets must be
flush against a flat mounting surface. Do not
mount brackets oncurved molding.
End of Headrail
Window/Door Opening
8"
8"
Space Evenly Space Evenly
Top of
Bracket
Floor Clearance
Ordered
Shade
Height