INSTALLATION – VALANCE
34
Valance Attachment
Attach Valance Clips
■
Attach the valance clips to the headrail.
➤
Position the bottom of the valance clip under the bottom lip of the headrail.
➤
Rotate the valance clip up to snap it into place on the top of the headrail.
➤
Keep a minimum of 3" between the end of the headrail and the valance clips.
NOTE: Use the valance clips to hold the wire from the motor to the control button in
place.
IMPORTANT: Be sure to avoid areas where the headrail attaches to the installation
brackets.
■
See the appropriate page for your type of valance:
➤
For Sydney III Aluminum Valance, see“Syndey III Aluminum Valance” on page 35.
➤
For EverWood
®
Grandover
TM
Alternative Wood Valance, see“Alternative Wood
Valance” on page 38.
Headrail
Valance
Clip
To Next Page
Loading...
