HunterDouglas Duette - Declarations and Safety; Regulatory Compliance Statements

CARE
45
Removing the Shade
You will need two people to remove the shade.
■
Detach the stationary rail bottom bracket from the wall or floor.
■
Remove the valance by reversing the installation procedures.
■
Hold the headrail assembly and, using a
small flat blade screwdriver, push back on
the bottom tab of the installation brackets to
release the headrail.
NOTE: Because the bracket may be stiff, the
headrail may be difficult to remove. Twist the
screwdriver blade slightly as you push back
the bottom tab to help remove the headrail
from the bracket. Be careful not to scratch the
finish on the back of the headrail.
■
Place the entire Vertiglide
™
shade
assembly (headrail, vertical rails,
and fabric panels) on the floor.
■
To remove the fabric panels from
the headrail for cleaning, reverse
the steps stated in “Install the
Fabric Stack” on page 12.
Cleaning Procedures
Hunter Douglas Duette
®
Honeycomb Shades are made of anti-static, dust-resistant fabric
which repels dirt and dust. For most honeycomb fabrics, the following cleaning options are
available.
Dusting
■
Regular light dusting with a feather duster is all the cleaning needed in most
circumstances.
Vacuuming
CAUTION: Do not vacuum Elan
®
fabrics.
■
For deeper cleaning, vacuum gently with a brush attachment.
Compressed Air/Hair Dryer (Cool Setting)
■
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off shades.