HunterDouglas UltraGlide - Resetting the Shading (if Necessary)

OPERATION
26
Resetting the Shading (If Necessary)
Calibration Reset
The calibration reset is used to recalibrate the shading’s travel limits. This action is performed
in the PowerView
®
App.
■
Select Calibrate Shade in the Advanced Options section of the Shade Settings menu in the
PowerView App.
■
Both the front shading and back panel will touch off on the top. Next, the front shading
will lower, vanes will over-rotate, and then the back panel will move to the closed
position. The back panel will raise back up to the top, and then the vanes will close. When
the shading and back panel stop moving, calibration is complete.
Resetting Shading Programming
The PowerView App may be used to modify or reset any shading programming to PowerView
®
Gen 3 remotes and gateways. Shadings may be added to or removed from Rooms in the
app at any time. If necessary, shadings may also be deleted from the PowerView App in the
Advanced Options section of the Shade Settings menu.
Electronic Limit Adjustments
Electronic limits are set at the factory and normally do not require readjustment. For window
treatments that may need additional adjustment or to set custom limit positions, go to Shade
Settings in the PowerView App to adjust limits.