CARE
35
Removing the Shading
■
Fully raise the shading.
■
Disconnect the power source from the power cable at the
back of the shading.
■
Move each lever of the installation brackets to the left to
release the shading.
CAUTION: A flat blade screwdriver can be used to move
the lever. Be very careful not to tear or damage the fabric.
■
Carefully pull the headrail to completely remove the
shading from the brackets.
Cleaning Procedures
Silhouette
®
Halo
™
Window Shadings are made of 100% polyester, which means they are
inherently durable and resilient. However, care must be taken to avoid wrinkling the fabric,
particularly where the vanes meet the facings.
The Palette
®
Fabric-Covered Headrail
■
Spot-clean the headrail using a sponge or delicate cloth, cool distilled water and a mild
soap solution; handle with care as you would any fine fabric.
Dusting
■
Regular light dusting with a feather duster is all the cleaning needed in most
circumstances.
Vacuuming
■
Use hand-held vacuum with low suction, for more thorough dust removal.
Forced Air
■
Blow away dirt and debris between the vanes using clean compressed air.
Spot-Cleaning
■
Do not spot-clean anything other than the Palette
®
Fabric-Covered Headrail on Silhouette
Halo Window Shadings.
Ultrasonic Cleaning
■
Silhouette Halo Window Shadings cannot be ultrasonically cleaned.
■
Never immerse the headrail in the solution.
Injection/Extraction
■
Silhouette
®
Halo
™
Window Shadings can be professionally cleaned using the injection/
extraction method.
Move the lever to the left
to release the shading.
Top View
To Next Page
Loading...
