OPERATION
21
Operate the Shading
A single control is used to operate both the front window shading and the rear roller shade.
Operation is sequential. The front shading must be lowered and the vanes over-rotated before
the rear roller shade can be lowered. Conversely, the rear roller shade must be raised before
the vanes on the front shading can be closed and the front shading raised.
CAUTION: When raising the front shading or rear shade for the first time, observe how the
fabric rolls up into the headrail. It should roll up evenly. If the bottom rail is not level or the
fabric starts to rub against either window jamb, immediately stop the front or back shade from
operating. See “Adjusting the Bottom Rail Weight” on page 31.
■
For operation instructions, refer to the appropriate page based on your operating system.
➤
For the UltraGlide
®
system, see page 22.
➤
For the PowerView
®
Gen 3 Automation system, see page 23.
To Next Page
Loading...
