English – 43
Repair Instructions
3
Fit the carburetor and make sure the lug on the
carburetor hooks in place on its mounting on the
intake system. See gure 46.
Make sure that the following components are
correctly fitted:
• Position the air lter holder against the
carburetor.
• Make sure the carburetor cover's intake channel
is aligned correctly with the slot for the air lter
holder.
• The spring must be tted under the choke pin on
the carburetor. See gure 47.
• The rubber collar on the stop button must be
on the inside of the bottom of the carburetor
compartment. See gure 47.
NOTE! Make sure that the fuel and return hoses
are not crushed.
Fig 46
Fig 44
Fig 45
Fitting on the saw
1
Press the connector together as outlined in
gure 44 and press it into place in the holder.
Fig 47
2
Connect the cables to the stop switch.
See gure 45.
To Next Page
Loading...
