HygroMatik Basic - Page 18

Page 18
With double-cylinder humidifi-
ers the control for the second
cylinder (the right one) is ad-
justed to an „external control
signal, 0-10V“ (factory setting).
Active sensor
Humidifier Terminals
Connection: active sensor;
current output, single-cylinder
and double cylinder units, two-
wire system
Setting the parameter to the
output signal from the active
sensor.
Parameter
Set U6 to “PI-control” and
E3 to “0-10 V”
The desired relative humidity
value is set at Parameter P8
Basic
Comfort / Comfort Plus
Please note
Setting for Sensor Signal:
0(2)-10 V DC