Hytera X1p Owner's Manual

16
Emergency
Mode
Description
Emergency
Call
In this mode, press the programmed
Emergency On key to go to the
Revert Channel, and you can hold the
PTT key to speak into the microphone
when the icon appears. Your
voice and background noise to be
transmitted automatically.
Note: If the Alarm with Call To
Follow feature is enabled by your
dealer, you can speak into the
microphone without holding the
PTT key.
This mode will be unavailable
when the Emergency ID is not
sent or 5-Tone Emergency ID is
sent.
Operation Methods for Analog Emergency
Alarm (None, 5-Tone & HDC1200)
Initiating an emergency alarm:
Press the programmed Emergency On key to send
alarm information.

None, HDC1200: The radio displays icon
and text information “Sending Alarm”, with the
LED glowing red.

5-Tone: The radio sends the ID first (the icon
and text information “Sending ID” will be
displayed), and then transmits the emergency
alarm (the icon and text information “Sending
Alarm” will be displayed), with the LED glowing
red.
Note: As for None and 5-Tone emergency
ID type, if “Local Emergency Alarm” is
enabled via the programming software, the
radio will give an alarm tone.
Exiting the emergency alarm:
The emergency alarm initiator exits the Emergency
mode in any of the following ways:

Press the programmed Emergency Off key.

Turn the radio off.

Once the Alarm Cycles expire, the radio will exit
the Emergency mode automatically.

Hold the PTT key to exit the Emergency mode.
The radio will transmit the voice on the channel
where the radio operates before entering the
Emergency mode (for HDC1200 only).
The emergency alarm receiving party exits the
Emergency mode in any of the following ways:

None: When an alarm is received, the receiving
party can press any key to exit the emergency
alert. When the alarm initiator exits the
Emergency mode or when the Alarm Cycles
expire, the receiving radio will exit the emergency
alert automatically.

5-Tone: When an alarm is received, the receiving
party can press any key to exit the emergency
alert.

HDC1200: When an alarm is received, the
receiving party can exit the emergency alert by
pressing the TK key within 2s after pressing the
Back key, or switching the channel or powering
off the radio.
Alarm with Call (None, 5-Tone & HDC1200)
Initiating an emergency alarm:
1. Press the programmed Emergency On key to
send alarm information.
»
None, HDC1200: The radio displays icon
and text information “Sending Alarm”, with
LED glowing red.
»
5-Tone: The radio sends the ID rst (the icon
and text information “Sending ID” will be
displayed), and then transmits the emergency
alarm (the icon and text information
“Sending Alarm” will be displayed), with the
LED glowing red.
Note: As for None and 5-Tone emergency
ID type, if “Local Emergency Alarm” is
enabled via the programming software, the
radio will give an alarm tone.
2. If the Alarm with Call to Follow feature is enabled,
you can speak into the microphone to make an
emergency call when the radio displays the icon
.
3. And when a call is received, the icon
appears.
4. If the preset Voice Cycles expire, you can hold
the PTT key to make the emergency call again
(the radio displays the icon , with the
LED glowing red). After the emergency call is
transmitted, release the PTT key to receive (the
radio displays the icon , with the LED ashing
orange rapidly). And when a call is received, the
icon appears (for HDC1200 only).
Exiting the emergency alarm:
The emergency alarm initiator exits the Emergency
mode in any of the following ways:

Press the programmed Emergency Off key.

Turn the radio off.

Hytera X1p Specifications

General

Brand	Hytera
Model	X1p
Category	Portable Radio
Language	English