32
15.6.3 How to Apply Grease
1) When greasing the guide, use a spatula or grease applicator to squeeze or inject grease into the
space between the slider and base, and then move the slider back and forth several times to let the
grease spread evenly.
Apply grease on the guides on both sides.
Remove excess grease.
2) When greasing the ball screw, clean the ball screw, apply grease using a finger, and then move the
slider back and forth several times to let the grease spread evenly.
At this time, be careful not to deform the stainless sheet by accidentally touching the sheet.
Remove excess grease.
3) Install the side covers.
Tightening torque: Thin-head screw M3 x 6 – 87.2 Ncm (8.90 kgfcm)
Refer to 3) in 15.4, “Interior Inspection,” for notes on installing the side covers.
Caution: If the actuator is equipped with a microswitch (optional), carefully install the side
covers so that the switch cables are not pinched.
To Next Page
Loading...
