IBM 3409-S03 User Manual

Figures
1. Lifting hazard ............ 2
2. Chassis label (FCC compliance) ...... 3
3. Module bay caution label ........ 4
4. Hot surface warning label ........ 4
5. PSU warning label .......... 5
6. Drawer caution label .......... 5
7. Enclosure front view .......... 9
8. AP-TL-1 module locations........ 10
9. AP-LS-1 module locations........ 10
10. Drawer LEDs (left side only) ....... 12
11. A disk drive in carrier (DDIC) ...... 12
12. Enclosure operator’s panel ....... 14
13. 2200 W PSU ............ 15
14. PSU LEDs ............. 15
15. 2800 W PSU ............ 16
16. PSU LEDs ............. 16
17. Cooling module ........... 17
18. Cooling module LEDs ......... 18
19. AP-TL-1 module ........... 18
20. AP-LS-1 module ........... 19
21. Unpacking the system ......... 22
22. Mounting the system into a rack (left rail only) 23
23. Rear enclosure mounting ........ 24
24. PSU Power Switch and LEDs ...... 27
25. Ops panel LEDs ........... 28
26. Anti-tamper locks .......... 30
27. PSU LEDs ............. 31
28. Cooling module LEDs ......... 32
29. Operator’s panel LEDs ......... 33
30. Drawer LEDs (left sideplane only) ..... 35
31. Drive Fault LED ........... 36
32. Compute module LEDs ........ 36
33. Anti-tamper locks (shown disengaged) 42
34. Opening the bottom drawer ....... 42
35. Drawer latch ............ 43
36. Drive location plan .......... 43
37. Removing a DDIC .......... 44
38. Installing a DDIC .......... 44
39. Latch position of a correctly inserted drive 45
40. Cooling module LEDs ......... 45
41. Removing a Cooling Module (1) ..... 46
42. Removing a Cooling Module (2) ..... 46
43. Removing a PSU module (1) ....... 47
44. Removing a PSU Module (2) ....... 47
45. AP-TL-1 compute module LEDs ..... 48
46. AP-LS-1 module ........... 48
47. Removing a module (1). ........ 49
48. Removing a module (2). ........ 49
49. Remove the battery .......... 50
© Copyright IBM Corp. 2016, 2018 v

IBM 3409-S03 Specifications

General

Brand	IBM
Model	3409-S03
Category	Storage
Language	English