IBM 6400 Series - Page 103

103Troubleshooting
If the message appears, replace the CMX controller board. Record the
message and return it with defective CMX board.
133 RIBBON INVALID STATE
SEE USER’S GUIDE
1. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears, download
the emulation software again.
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record the
message and return it with defective CMX board.
134 PLA
TEN INV ALID COMMAND
SEE USER’S GUIDE
1. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears, download
the emulation software again.
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record the
message and return it with defective CMX board.
135 PLA
TEN INV ALID STATE
SEE USER’S GUIDE
1. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears, download
the emulation software again.
2. Cycle power. Run the print job again.
If the message appears, replace the CMX controller board. Record the
message and return it with defective CMX board.
136 PLA
TEN INV ALID PARAMETER
SEE USER’S GUIDE
1. Firmware error on the CMX controller board.
Cycle power. Run the print job again. If the message appears, download
the emulation software again.
2. Cycle power. Run the print job again.