159
Adjustment Procedures
Returning the Printer to Normal Operation
When you are finished servicing the printer, restore it to operation by
following these steps:
1. Connect the host data cable to the printer interface.
2. Install the ribbon.
3. Load paper.
4. Plug the AC power cord into the power source.
5. Close the cabinet doors.
6. Power on the printer.
7. Set the top-of-form. (Refer to the
Operator’s Guide
.)
8. Select the emulation. (Refer to the
Operator’s Guide
.)
9. Test printer operation by selecting and running one of the operator print
tests.
10. Close the printer cover.
To Next Page
Loading...
Need help?
General
