245
Replacement Procedures and Illustrated Parts List
Ribbon Hub
Removal
1. Prepare the printer for maintenance (page 194).
2. Remove the printer ribbon.
3. Loosen the Torx T-10 screw in the ribbon spool hub (page 285,
Figure 50).
4. Remove the hub from the shaft of the ribbon drive motor.
Installation
1. Install the ribbon spool hub over the motor shaft (page 285, Figure 50).
2. Tighten the hub screw so that it contacts the flat section of the motor
shaft.
3. Return the printer to normal operation (page 159).
To Next Page
Loading...
