210
Replacement Procedures and Illustrated Parts List
Cover Assembly, Top, Pedestal Model
Removal
1. Prepare the printer for maintenance (page 194).
2. Remove the operator panel (page 234).
3. Remove five screws and the control panel bracket. (See Figure 42, page
267, items 3 and 4.)
4. Loosen the two captive #2 Phillips screws in the lower front corners of
the top cover. (See Figure 42, page 267, item 14.)
5. Loosen, but do not remove, the two #2 Phillips hold-down screws on the
rear of the printer. (See Figure 42, page 267, item 8.)
6. Lift the top cover assembly off the printer base.
Installation
To install the top cover assembly, reverse the steps of the removal
procedure.
To Next Page
Loading...
Need help?
General
