112 Troubleshooting
2. Install the flash and DRAM SIMMs, making sure they are fully and correctly
seated. Power on the printer. Download the emulation.
If the message appears, replace the flash SIMM(s). (See Figure 34, page
226.)
3. Power on the printer. Download the emulation.
If the message appears, replace the DRAM SIMM(s). (See Figure 34,
page 226.)
4. Power on the printer. Download the emulation.
If the message appears, replace the CMX controller board. Record the
message and return it with defective CMX board.
PLEASE W
AIT...
RESET IN PROGRESS
1. Status message: the printer finished loading the program into flash memory and
is automatically resetting itself.
No action required.
READY
1. Printer state message: the printer is online.
No action required.
RESETTING...
PLEASE W
AIT
1. Status message: the printer is resetting itself.
No action required.
RESTORING BOOT CODE
1. Status message when downloading boot code. Code is checked then saved in
flash memory.
No action required.
RIBBON OUT OF INK
CHANGE RIBBON
1. RibbonMinder software has determined that the ribbon is out of ink.
Install a new ribbon and set ribbon life to 100%.