IBM 6400 Series - Page 141

141Troubleshooting
Step NotesDisplayed ResultKey
5. Press:
Scroll
UNTIL
PRINTER MECHANISM TESTS
Plot T est
Cycles through the list
of mechanism tests.
Stop when the name of
the test you wish to run
displays.
6. Press:
Scroll
Scroll
+
OPERATOR MENU
UNLOCKED
Press both keys at the
same time. You must
unlock the Enter key to
run a test.
7. Press:
Enter
Plot T est
Running
The test starts. See
Chapter 6 for special
instructions in the use of
the Hammer Phasing
and End of Forms Adjust
tests.
8. Press:
Stop Start
–OR–
(NOT) READY
Stop halts the test, exits
the menu, and puts the
printer in the NOT
READY state. Start
halts the test, exits the
menu, and puts the
printer in the READY
state.