241
Replacement Procedures and Illustrated Parts List
Platen Installation (continued)
17. Install the platen shaft pulley with the 7/64 inch setscrew facing up and
tighten the setscrew. Open and close the forms thickness lever and
check that the platen pulley setscrew does not hit the left ribbon guide.
18. Install, but do not adjust, the platen open belt and platen open motor
pulley (page 197).
19. Install the paper ironer with the black tape towards the rear of the printer
(page 236).
20. Install the shuttle frame assembly (page 249).
21. Adjust the platen gap (page 168).
22. Adjust the platen open belt (page 162).
23. Check ribbon guide alignment (page 172).
24. Check the hammer phasing (page 179).
25. Return the printer to normal operation (page 159).
To Next Page
Loading...
