384 Power Stacker
4.Connect the power stacker logic cable P103 to connector J17 on the
CMX controller board. (See Figure 66.)
5.Disconnect the power supply cable from connector J101 on the CMX
controller board. (See Figure 66.)
6.Connect power supply cable connector P101 to the stacker power cable,
then connect the stacker power cable to connector J101 on the CMX
controller board. (See Figure 66.)
7.Route the stacker power cable and the stacker logic cable in
front of the
CMX board and through the cutout beneath the card cage fan, as shown
in Figure 66.
Stacker Power
Cable P102 to J101
Stacker Logic
Cable
Power Supply
Connector P101
CMX Board
Connector J17 to P103
Cutout Beneath
Card Cage Fan
CMX Board
Connector J101
Connector P103
Figure 66. Stacker Power and Logic Connections on the CMX Controller Board
To Next Page
Loading...
Need help?
General
