73Troubleshooting
010 P
ARAMETER ERROR
1. The printer received an illegal parameter value in the command code.
Press Stop to clear fault. Press Start to go on-line.
2. Run the print job that generated the error message.
If the message appears, check the host data for invalid characters.
3. Ask the system operator to verify that the printer’s Device ID is set to the correct
emulation with respect to the host configuration.
Set printer Device ID to the correct emulation with respect to the host
configuration.
4. Run the print job that generated the error message.
If the message appears, go to Communications Failures, page 133.
011 SCS COMMAND ERROR
1. The printer received an undefined control character (hex 40) through the
coax/twinax interface.
The printer clears the error.
2. Run the print job that generated the error message.
If the message appears, verify that there are no invalid control codes in
the host data.
3. Ask the system operator to verify that the printer’s Device ID is set to the correct
emulation with respect to the host configuration.
Set the printer Device ID to the correct emulation with respect to the host
configuration.
4. Run the print job that generated the error message.
If the message appears, go to Communications Failures, page 133.
012 STRUCTURED FIELD ERROR
1. Application software has violated structured data field parameters.
Not a printer problem. Have the system administrator correct applications
data or configuration.
To Next Page
Loading...
Need help?
General
