IBM 9080-M9S

• If you have a single node system conguration, use Figure 157 on page 184 and Table 20 on page
184 to determine the point-to-point cabling for UPIC cables.
Figure 157. Single Node Conguration UPIC Cabling
Table 20. Single Node
Conguration UPIC Cabling
Cable number From To
1 SC1: P1-C1-T1 ND1: P1-C9-T1
2 SC1: P1-C2-T1 ND1: P1-C10-T1
• If you have a two, three, or four node system conguration, use Figure 158 on page 185 and Table
21 on page 185 to determine the point-to-point cabling for UPIC cables.
184
Power Systems: Removing and replacing parts in the 9080-M9S system